9
Replacing the rear fan filters
1
Open the hood:
a
In Print Console, unlock the panels.
b
Push the black button and lift the rear hood.
5
4
2
Rear fan filter
3
Remove the old rear fan filters and insert new
filters.
Use the air flow arrow as a guideline for correct
installation. The arrow should point toward the
fan so that the side with the wire mesh faces the
interior of the platesetter.
The Magnus VLF platesetter has two fans at the rear of the platesetter. Replace the filters for these fans every six months.
Use a slotted screwdriver
to loosen the two screws
that secure the rear panel
to the platesetter.
Close the rear panel, tighten the
screws, and close the rear hood.
In Print Console, lock the panels.
To Next Page
Loading...
