10
Raising the punch assembly
1
Open the rear hood:
a
In Print Console, unlock the panels.
b
Push the black button and lift the rear hood.
Punch assembly
2
Standing in front of the punch assembly, pull
it toward you.
3
Remove the lifting handle from its storage location.
Lifting handle
4
Push in the blue lock-out knob.
Blue lock-out knob
Crankshaft
5
Attach the lifting handle to the crankshaft
and slowly turn the lifting handle clockwise.
Lift the punch assembly until it reaches your desired
level or is in the fully up position.
The blue light turns on when the
punch table starts to lift.
The punch assembly in the fully up
position.
You may need to raise the punch assembly to perform a recovery procedure. Raising the punch
assembly provides access to the unload table, the load table, and the top of the drum.
To Next Page
Loading...
