Kodak Magnus VLF Q2400 - Page 14

13
Removing a plate flyo
CAUTION: Wear protective
gloves when handling
plates to protect your
hands from the sharp edges
and corners of the plates.
Failure to wear protective
gloves may result in minor
or moderate injury.
8
Reposition the trailing-edge clamps:
a
b
Using the clamp removal tool, lift the trailing-
edge clamps and reposition them. Twist and
pull to remove the clamp removal tool.
Align the trailing-edge clamps so
that their edges press against the
parking pins.
Parking pins
Edge of trailing-edge clamp
9
Replace the rear panel and close
the rear hood.
10
In Print Console, lock the panels.
11
In Print Console, click Media
Removed.
3
Pull the cooling fans away
from the drum.
Cooling fans
4
Rotate the drum to expose the
trailing-edge clamps.
5
Using the clamp removal tool, slide the
trailing-edge clamps o the plate.
6
Fold over the corners of
the plate.
7
Press the leading-edge clamps
to free the plate.
The clamp
removal tool
is stored in
the rear of the
platesetter.
An error message about the
flyo appears.
1
Open the hood:
a
In Print Console, unlock the
panels.
b
Push the black button and lift the rear hood.
2
Use a slotted screwdriver
to loosen the two screws
that secure the rear panel
to the platesetter.