Kodak Magnus VLF Q2400 - Types of safety messages

12
Replacing the debris removal filter
3
4
1
1110
9876
5
12
Shut down the
platesetter by turning
the power switch to
the OFF position.
Pull the debris panel toward
you. The panel unlatches.
Lift the panel up and away
from the platesetter and put
it in an out-of-the-way place.
Vacuum any dust
deposits from around
the tube in the center of
the inner lid. Ensure that
no debris falls into the
filter compartment.
Release the canister lid on the debris
removel unit by pulling the pins on
either side.
Slide the debris removal unit out of
the platesetter and remove the old
filter by grasping the handle and
pulling up.
Place the used filter in
a bag for disposal. A
bag is provided with the
replacement filter.
Remove the filter spacer
from the bottom of the filter
compartment and put it aside.
Reinstall the filter spacer in the
bottom of the filter compartment.
Wipe the inside of the inner lid, the
deck, and the interior surfaces of
the filter compartment with a clean
rag dampened with water and mild
detergent. Remove all residue by wiping
thoroughly with a clean, damp rag.
15
14
13
WARNING: Do not let water or other liquids run freely into the
platesetter. This can result in serious injury from electrical shock as
well as damage to your platesetter.
Press down on the cannister lid
until you hear a click.
Lower the new filter into the filter
compartment with the gasket
facing up. Ensure that the filter is
fully seated on the spacer.
Slide the debris removal
unit back into the
platesetter.
Align the locating holes
on the bottom of the
panel with the locating
pins on the platesetter.
Push the upper corners of
the panel until you hear
both latches click.
On the Print Console Messages tab,
follow the instructions for clearing the
message.
Wash your hands.
Print Console indicates when the debris removal filter is full and needs to be replaced. When the full filter message appears, you will not be able to continue imaging until the filter is replaced.
Click Eject to eject any plates that are
in the platesetter.
2
Clean the debris removal compartment:
b
a
Reinstall the filter:
b
a
Gasket
Filter spacer
Filter
Replace the panel:
a
b
Lower the bottom of the
panel onto the pins.
Always have a spare filter on hand.