2
Emergency stop button
Emergency stop button
Power switch
Emergency stop locations
Emergency stop button
Press the emergency stop button to stop
mechanical movement and laser operation.
Activate an emergency stop device to stop mechanical movement and laser operation.
Power/emergency stop switch
The power switch disconnects power to the platesetter so
that you can safely perform maintenance procedures or
retrieve stuck media. When you are instructed to turn o
power to the platesetter, turn the switch counterclockwise to
the OFF position and secure it with a padlock.
To turn on the power,
turn the switch
clockwise to the ON
position.
Insert a padlock here.
OFF ON
The switch can be used as an emergency
stop mechanism when you cannot reach an
emergency stop button.
To reset the platesetter, turn the
emergency stop button clockwise until
it pops up and then select the Reset
operation in Print Console.
The emergency stop button stops laser operation
and mechanical movement, but the power remains
connected. If any internal or external emergency
stop button is pushed, you must reset the
platesetter before it can resume regular operations.
To Next Page
Loading...
