4
Double plates
Right side
Ensure that the platesetter has a
Ready status.
2 3
Ensure that the correct plate size is available
for loading.
Single plate
Double plates
4
Pull out the bypass load table.
5
Place the plate or plates on the load table.
6
Remove the slip sheet.
7
Align the plate or plates with the media
alignment labels.
Plate
Media alignment labels
8
Register the plate or plates. Position the
leading edge against the end stop.
9
Press a start button.
Double plates
Double plates
Single plate
Single plate
Left side
Loading and imaging a plate
Kodak Prinergy® Connect™ workflow
CAUTION: Wear protective gloves when handling plates to protect your hands from the sharp edges
and corners of the plates. Failure to wear protective gloves may result in minor or moderate injury.
In the workflow software, submit the file.
Kodak Brisque® workflow
Note: You must have a Prinergy Evo TIFF output
template and hot folder already set up.
Single plate
The exposed plate or plates exit the
platesetter through the bridge.
1
On the Print Console Queue tab, follow
the progress of the plate or plates
through the platesetter.
10
Kodak Prinergy Evo™ workflow
Accurate alignment ensures accurate
punching. Ensure that the plate is no farther
than 3 mm (0.12 in.) from the alignment
label.
To Next Page
Loading...
