5
Operation
Turn on the platesetter
1
These operations are required for some of the
maintenance procedures below.
Turn o the platesetter
2
Reset the platesetter
3
Maintenance procedure Work to be done How often
Date work
completed
Exterior surfaces Clean
Weekly
Edge detection strip
1
4
Clean
Six months or
as needed
Plate roller
1
5
Clean
Rear fan filters
1
6
Replace
328-00036
Punch chip collection box
1, 3
Empty
Compressed air supply
(particulate filter only)
1
8
Replace
328-00001
Power box intake air filter
1
9
Replace
55-1292A
Heat exchanger intake air
filter
1, 2
10
Replace
55-1293A
As needed
Debris removal filter
1
Replace
MDRC: 252-11119A
UDRC: 57-8792D
As needed
1
This procedure is included in this visual reference guide.
2
This procedure applies only to models with the heat exchanger option.
3
This procedure applies only to models with the punch option.
For more information, see the Print Console User Guide.
Operator maintenance schedule
4
5
1
2
7
8
10
9
3
6
7
11
11
To Next Page
Loading...
