52
5. Code Reference
Related information code will be displayed on LCD screen. Please check inverter LCD screen for the operation.
If battery status is not allowed to charge
and discharge after the communication
between the inverter and battery is
successful, it will show code 60 to stop
charging and discharging battery.
Communication lost (only available when
the battery type is setting as “Pylontech
Battery” or “WECO Battery” or “Soltaro
Battery” or “BAK Battery”.)
After battery is connected,
communication signal is not detected
for 3 minutes, buzzer will beep. After
10 minutes, inverter will stop charging
and discharging to lithium battery.
Communication lost occurs after the
inverter and battery is connected
successfully, buzzer beeps
immediately.
Battery number is changed. It probably is
because of communication lost between
battery packs.
Press “UP” or “DOWN” key to switch LCD
display until below screen shows. It will
have battery number re-checked and 62
warning code will be clear.
If battery status is not allowed to charge
after the communication between the
inverter and battery is successful, it will
show code 69 to stop charging battery.
If battery status must to charge after the
communication between the inverter and
battery is successful, it will show code 70
to charge battery.
If battery status is not allowed to discharge
after the communication between the
inverter and battery is successful, it will
show code 71 to stop charging battery.
To Next Page
Loading...
