79
Connecting to your Printer
1. Make sure both the camera and printer are turned
on.
2. Connect one end of the supplied USB cable to the
USB port on your camera.
3. Connect the other end of the cable to the USB port
on the printer.
If the camera is not connected to a PictBridge com-
patible printer, the following error message will appear
on the LCD screen.
The error message above will also appear if
the USB mode is set incorrectly, in which case
you should disconnect the USB cable, check
the USB mode settings, ensure that the Printer
is turned on, and then try connecting the USB
cable again.
To Next Page
Loading...
