Kodak RETINA IIIC

he ocu -ng Ie
In addition to using the coupled rangefinder to
determine distance automatically, you can also set
the FOCUSING SCALE (for 50mm lens) manually for
film plane-to-subject distance. Set the correct film
plane-to-subject distance on the focusing scale
opposite the FOCUSING INDEX.
The small red dot next to the focusing index is
to be used instead of the focusing index when
focusing with Infrared Film. Therefore, turn the
focusing knob until the figure corresponding to
the film plane-to-subject distance is opposite the
red dot when using infrared film.
The bottom of the focusing ring carries three
other scales. These are for use with the inter-
changeable lenses which are described on page 28.
"el
After you have properly focused on your subject,
the subject will be sharp in the picture . However,
22