LOADING-in
subdued
light
1.
To
open
the
back
of
the
camera,
press the
MILLED
LEVER
clockwise; the opposite end
of
the
lever then uncovers the opening
BUTTON.
Pr
ess this
button
and the
back
springs open.
2.
Pull
out
the
REWIND
KNOB.
3.
Pl
ace the film magazine
in
the recess next to the
rewind knob.
Push
the rewind knob a
ll
the way
in
,
turning it slight
ly
if necessary.
4.
Turn
the built-in
TAKE-UP
SPOOL
by one
of
its
toothed flanges until a slot points upward. With the
lower edge
of
the film against the lower take-up
spool flange, push the film end
protruding
from the
magazine far
enough
into this slot to
anchor
a per-
foration over the small pin.
5.
Turn
the take-up spool by one
of
its flanges until
the
SPROCKET
TE
E
TH
engage the
perfor
ations
on
both
si,des
of
the film, as shown in the illustration.
6
To Next Page
Loading...
