34 A-61796 January 2017
NOTES:
• Email destination notifications are sent only when Background
Processing is enabled.
• If Success and Failure are both unchecked, an email notification
will not be sent.
• If Success is checked and you are outputting to several
destinations, you will only receive a success notification if all the
destinations were successful. If any one of them fails, a
notification will not be sent.
•If Fast Scanning is enabled, the user cannot enter a notification
email address before scanning.
• If the Email Address field is set and the user enters a notification
email address before scanning, notifications will be sent to both
email addresses.
• For email destinations, the notification message, “Email
message(s) have been queued” will be displayed.
• For fax destinations, the notification message, “Fax(s) have
been queued” will be displayed.
• Email destinations use the Return Email Address field in the
Email Server settings when an email cannot be delivered.
• Fax destinations use the Fax Notification Email Address field in
the Fax settings when a fax cannot be delivered.
12.Click Test Connection if you want to check to be sure your settings
are correct. When finished, a Success or Failure message will be
displayed. If the test connection failed, verify that all of your settings
are correct and make any necessary changes, until a Success
message is displayed.
NOTE: You may need to use the scroll bar to access the Test
Connection button.
Depending on the options you selected on the main Device Settings
screen, you will have the option of clicking Next which will display the
next device you want to configure, or Finish which will return you to the
Configuration tab.
To Next Page
Loading...
