28 A-61818 April 2014
Once you have done this, the Side drop-down list on the Image
Settings window will no longer be grayed out and you can select
different settings for each side. Now that you have enabled Different
settings per side, your initial selections will apply only to the front side
of the document you are scanning. After you have made your
selections for the front side, use the Side drop-down list to select the
back side and then make the settings you want to apply to the back.
NOTE: The Different settings per side option is only available for duplex
scanner models.
Combine front and back images — typically, for a document, one
image is created for the front side and another image is created for the
back side. Turn this option on if you want one image that contains both
the front side and back side of the document. The selections are:
Front on Top: front side will be above the
back side within the image.
Front on Bottom: back side will be above
the front side within the image.
Front on Left: front side will be to the left
of the back side within the image.
Front on Right: back side will be to the
left of the front side within the image.
To Next Page
Loading...
