7
How to attach and remove the straps
Although only one strap is included in the box, it can be attached and removed easily. The
shorter strap must be placed in the display’s top slot, while the longer strap must be placed
in the display’s bottom slot. Otherwise, the insertion system may be irreparably damaged.
1. To remove a strap: Remove a strap from your smartwatch by depressing the
release mechanism near the connection point, sliding out the quick-release pins,
and repeating for both sides if necessary.
2. To attach a strap: Attach the new strap to your smartwatch by aligning the quick-
release pins with the slots on the watch case, sliding the pins into place, and
confirming a secure fit.
Charging
The smartwatch’s full charge time is approximately 3.5 hours and the battery can last up to
4-6 days depending on the usage.
Use the 45 cm USB-A cable with magnetic charging port that is included in the box to
charge the smartwatch. Connect the USB-A connector to a charger, computer output or
power bank and place the magnetic port in a way so that it sticks to the 2 pins featured on
the back part of the body watch.
Power on/off
• To turn on the smartwatch press and hold the top button for 4 seconds.
• To turn off the smartwatch press and hold the top button for 4 seconds.
You can also power off, restart or reset the smartwatch. To do so access the smartwatch
main menu and access the watch settings (gear icon). Scroll down and tap on system.
When you do so, you will see a list of three options: restart, power off and reset. Tap on the
desired option.
About IP protection rating
The Pulse 3 smartwatch has an IP68 protection rating. This means that it can withstand
being submersed under water 2 meters for up to 30 minutes.
Notes: In case of swimming in the sea or in a saltwater pool, it is recommended to
rinse the watch with fresh water after the immersion due to the corrosive effect of salt
water.
To Next Page
Loading...
