TP-6805 8/15 131Section 7 Disassembly/Reassembly
7.2.2 Remove Enclosure, 20RESB and
20RESD
Remove the generator set enclosure as described in the
following steps. See Figure 7-10.
1. Open the enclosure roof.
2. Press the OFF button on the controller.
3. Remove the screws on one end of the roof stay to
disconnect the roof stay. See Figure 7-11.
4. Remove one roof hinge: Use two screwdrivers to
compress the hinge springs. See Figure 7-11.
5. Remove the roof.
1. Roof
2. Service door
3. Air intake (front) panel
4. Heat shield (inside, not shown)
5. Panel
6. Non-service side panel
7. Exhaust end (rear) panel
ADV8564
1
2
4
5
3
6
7
Figure 7-10 Enclosure Parts, Order of Disassembly
1. Hinges
2. Roof
3. Door stay (GM51973)
Compress
hinge springs
2
3
1
Remove
two screws
Figure 7-11 Roof Stay and Hinges
To Next Page
Loading...
