TP-6161 1/12 49Section 6 Accessories
Section 6 Accessories
6.1 Accessories
Several electrical accessories and controls help
finalize installation, add convenience to operation and
service, and establish state and local code compliance.
Accessories vary with each generator set model and
controller. Select factory-installed and/or shipped-
loose accessories. See Figure 6-1 for a list of available
kits. Obtain the most current accessory information
from your local authorized service distributor/dealer.
This section illustrates several accessories availableat
the time of print of this publication. Accessory kits
generally include installation instructions. See the
wiring diagrams manual for electrical connections not
shown in this section. See the installation instructions
and drawings supplied with the kit for information on the
kit mounting location.
The instructions provided with the accessory kit
supersede these instructions where there are
differences. In general, run AC and DC wiring in
separate conduit. Use shielded cable for all analog
inputs. Observe all applicable national, state, and local
electrical codes during accessory installation.
Note: The accessories with the (DEC 3+) notation are
available only on models with Decision-Makerr
3+, 16-light microprocessor controller.
Kit Description
Audiovisual Alarm
Common Failure Relay (Terminal 32A)
Controller (Customer) Connection
Engine Prealarm Senders for NFPA 110
Fastcheckr Diagnostic Tester
Float/Equalize Battery Charger (with alarms)
Line Circuit Breaker
Low Fuel (Level) Switch
Low Fuel (Pressure) Switch
Prime Power Feature
Remote Annunciator
Remote Emergency Stop
Remote Serial Annunciator
Remote Speed Adjustment Potentiometer
(requires electronic governor), Non-ECM Models only
Run Relay
Safeguard Circuit Breaker
Shunt-Trip Line Circuit Breaker and Shunt-Trip Wiring
Single-Relay Dry Contact
Ten-Relay Dry Contact
Twenty-Relay Dry Contact
Figure 6-1 Optional Accessories
To Next Page
Loading...
