Kohler 20EKOZD - Page 62

TP-6953 7/1962 Section 2 Operation
SiteTecht Parameter
Write
Access
Units
Decision-Maker r 3500
User Interface
Notes
Engine Total Run Time Loaded None h Hours Loaded: #####hrs The total number of hours
that the engine has been
running while supplying
more than 1% of rated
genset load
Engine Total Run Time Unloaded None h Hours Unloaded: #####hrs The total number of hours
that the engine has been
running while supplying
less than 1% of rated
genset load
Engine Total Number Of Starts None Total # of Starts: ######## The total number of times
that the engine was
started via the genset
controller
Genset Total Energy None kW-h kW Hours: #####kWh The total amount of
energy that the genset
has produced
Engine Maintenance Period Hours Always h The number of hours
between engine
maintenance requirement
Genset Date Time Of Last Maintenance None Last Maintenance: ##/##/#### The time on the controller
system clock when the
last maintenance was
performed
Engine Run Time At Reset Maintenance None h The total number of hours
that the engine had been
running when the last
maintenance was
performed
Engine Run Time Until Maintenance None h The total number of
engine run hours that
remain before engine
maintenance is required
Genset Controller Hours Of Operation Since
Maintenance
None h Op Hrs Since Maint: ####hrs The number of hours that
power has been applied
to the genset controller
since maintenance was
performed
Engine Run Time Since Maintenance None h Eng Hrs Since Maint: ####hrs The number of hours that
the engine has been
running since
maintenance was
performed
Engine Run Time Loaded Since Maintenance None h Loaded Since Maint: ####hrs The number of hours that
the engine has been
running while supplying
more than 1% of rated
genset load, since
maintenance was
performed
Engine Run Time Unloaded Since Maintenance None h Unloaded Since Maint: ####hrs The total number of hours
that the engine has been
running while supplying
less than 1% of rated
genset load, since
maintenance was
performed
Engine Number Of Starts Since Maintenance None Starts Since Maint: ### The number of times that
the engine was started
via the genset controller,
since maintenance was
performed
Genset Energy Since Maintenance None kW-h kW Hrs Since Maint: ####kWh Theamountofenergy
that genset has produced
since maintenance was
performed
Engine Last Start Time None Last Start: ##/##/#### The date and time that
the engine was last
started via the genset
controller
Last Run Length None h Last Run Length: ####hrs The length of time that
the engine ran the last
time it was started via the
genset controller