150 Section 8 Decision-Makerr 3500 Controller TP-6953 7/19
5. Restore power to the generator set.
a. Reconnect the generator set engine starting
battery, negative (- ) lead last.
b. Reconnect power to the battery charger, if
equipped.
6. Set the device profile.
a. Connect the PC to the Decision-Makerr 3500
controller using a USB cable. See F igure 8-4
for the location of the USB connection port.
b. Start the SiteTecht application. Insert the
personality profile backup disk/drive and load
the data. Refer to the Tech Tools—Software
and the SiteTecht Software Operation Manual
for details.
c. Choose one of the following methods to load
the user parameters.
D Backup disk/drive. Use a PC with SiteTecht
software to load the data from the user parameter
backup disk/drive.
D Paper form. Use a PC to enter the user parameter
data from a filled-out form.
d. Create a new user parameter data backup
disk/drive if any changes are made using
SiteTecht software. Refer to the SiteTecht
Software Operation Manual for details.
e. Disconnect the USB cable.
f. Power down the unit by using the battery
disconnect switch (if equipped) o r by
disconnecting the battery negative (- ) terminal.
g. Wait at least 15 seconds and then power up the
unit by using the battery disconnect switch (if
equipped) or by reconnecting the battery
negative (- ) terminal.
h. Refer to the Decision-Makerr 3500 Operation
Manual TP-6861. Calibrate the generator set
as instructed in the Calibration submenu.
i. Press the RUN button to start the generator set.
j. Test the functionality of the controller by
reviewing the menus and observing the system
status lamps. Use the Operation Manual as
needed.
k. Press the OFF button to stop the generator set
after completing the test.
l. Reconnect the generator set to load by closing
the line circuit breaker.
m. Press the generator set master control AUTO
button for startup by remote transfer switch or
remote start/stop switch.
To Next Page
Loading...
