TP-6137 5/0372 Section 10 Generator and Engine Disassembly/Reassembly
Oil Pump
1. Loosen the three hex cap screws to remove the oil
pump from the crankcase. See Figure 10-51.
Figure 10-51 Oil Pump
Flywheel
1. Use a socket wrench and striker tool to loosen the
flywheel nut two turns. Keep the flywheel nut on the
shaft. See Figure 10-52.
Note: If removing the flywheel from the engine without
removing the governor, place the accelerator
lever in the higher speed (full load) position.
Otherwise, damage may occur to the regulation
linkage.
2. Install the flywheel puller.
3. Turn the two screws until the flywheel breaks loose
from the tapered side of the engine crankshaft.
See Figure 10-53.
4. Remove the nut and the flywheel.
Figure 10-52 Flywheel Nut
Figure 10-53 Flywheel
To Next Page
Loading...
