Kohler 6.5-27EFOZD

TP-6255 7/06 45Section 7 Controller
Section 7 Controller
7.1 Introduction
This section covers operation, configuration,
adjustment, and replacement of the ADC 2100
controller. See Section 6 for troubleshooting
procedures.
See Figure 7-1 for the locations of the controller and
related components. Section 7.2 describes the
controller keypad and display.
Section 7.3 describes the sequence of operation, and
faults are described in Section 7.4. Controller
configuration and adjustment are covered in
Section 7.5.
A silicon controlled rectifier (SCR) module works with
the controller to regulate the output voltage. See
Section 7.7.
A relay interface board (RIB) is used with the ADC
controller. Section 7.10 describes the standard and
optional RIBs.
1
GM29253
1. Junction box louvered panel
2. SCR module
3. Relay board
4. Engine harness-to-controller connection
5. Generator set master switch
6. ADC 2100
7. Line circuit breaker plate
8. Junction box
6
7
8
3
2
5
4
Figure 7-1 Advanced Digital Control (ADC 2100)