EasyManuals Logo

Kohler Command PRO EFI ECV940 User Manual

Kohler Command PRO EFI ECV940
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 62 590 18 Rev. DKohlerEngines.com
2. Turn key switch to START position. Release
switch as soon as engine starts. If starter
does not turn engine over, shut o key switch
immediately. Do not make further attempts to
start engine until condition is corrected. Do
not jump start. See your Kohler authorized
dealer for trouble analysis.
Cold Weather Starting Hints
1. Use proper oil for temperature expected.
2. Disengage all possible external loads.
3. Use fresh winter grade fuel. Winter grade
fuel has higher volatility to improve starting.
Stopping
1. If possible, remove load by disengaging all
PTO driven attachments.
2. Position throttle control between half and full
throttle; stop engine.
3. If equipped, close fuel shut-o valve.
Angle of Operation
Refer to operating instructions of equipment
this engine powers. Do not operate this engine
exceeding maximum angle of operation; see
speci cation table. Engine damage could result
from insu cient lubrication.
Engine Speed
NOTE: Do not tamper with governor setting to
increase maximum engine speed.
Overspeed is hazardous and will void
warranty.
Pre-Start Checklist
1. Check oil level. Add oil if low. Do not over ll.
2. Check fuel level. Add fuel if low. Check fuel
system components and lines for leaks.
3. Check and clean cooling areas, air intake
areas and external surfaces of engine
(particularly after storage).
4. Check that air cleaner components and all
shrouds, equipment covers, and guards are
in place and securely fastened.
5. Check spark arrestor (if equipped).
Starting
WARNING
Carbon Monoxide can cause
severe nausea, fainting or death.
Avoid inhaling exhaust fumes.
Never run engine indoors or in
enclosed spaces.
Engine exhaust gases contain poisonous
carbon monoxide. Carbon monoxide is
odorless, colorless, and can cause death if
inhaled.
WARNING
Rotating Parts can cause severe
injury.
Stay away while engine is in
operation.
Keep hands, feet, hair, and clothing away
from all moving parts to prevent injury. Never
operate engine with covers, shrouds, or
guards removed.
NOTE: To prime a dry fuel system, turn key
switch to ON position for one minute.
Allow fuel pump to cycle and prime
system. Turn key switch OFF.
NOTE: Do not crank engine continuously for
more than 10 seconds. Allow a 60
second cool down period between
starting attempts. Failure to follow
these guidelines can burn out starter
motor.
NOTE: Upon start-up, a metallic ticking may
occur. Run engine for 5 minutes. If
noise continues, run engine at mid
throttle for 20 minutes. If noise persists,
take engine to your local Kohler
authorized dealer.
1. Place throttle control midway between slow
and fast positions.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kohler Command PRO EFI ECV940 and is the answer not in the manual?

Kohler Command PRO EFI ECV940 Specifications

General IconGeneral
Fuel SystemElectronic Fuel Injection (EFI)
LubricationFull pressure lubrication with full-flow filter
Cooling SystemAir-cooled
Governor TypeMechanical
StarterElectric
Spark Plug Gap0.030 in. (0.76 mm)
Displacement999 cc
Bore90 mm
Oil Capacity2.0 quarts (1.9 liters)
Horsepower38 hp
Ignition SystemElectronic
Alternator20 amp
Fuel Tank CapacityExternal Tank Required

Related product manuals