7. Installation Checkout
Handshower
Diverter
Aerator
Install the Handshower Hose
Install the handshower hose to the handshower diverter.
Flush Debris and Check for Leaks
Verify that the faucet handle is in the OFF position.
Remove the aerator from the spout.
Turn ON the water supply and check for leaks.
Point the hose into the bath, and turn the faucet handle to the ON position.
Pull out the diverter to route water through the hose and remove debris.
Turn OFF the faucet to reset the diverter.
Turn ON the faucet and run hot and cold water through the spout to remove
debris.
Check for leaks.
Kohler Co. 11
1443292-2-B
To Next Page
Loading...
Need help?
General
