Kohler Courage XT-6

4.3
Section 4
Air Cleaner and Air Intake System
4
NOTE: Before reinstalling an air cleaner base that has
been removed, make sure the metal bushings
in the base mounting holes are present. The
bushings prevent damage to the base and
help maintain the proper mounting torque.
Reassembly
The following procedure outlines complete
reassembly of all air cleaner components.
1. Reconnect the primer bulb hose (if equipped). See
Figure 4-3.
2. Install the air cleaner base onto the mounting
studs.
ȱ řǯȱ ȱȱȱȱȱȱȱȱ¡ȱĚȱ
nuts and the hex screw. Torque all three to 8.1
N·m (72 in. lb.).
4. Reconnect the breather hose. See Figure 4-2.
5. Install the air cleaner element with the pleated
side out.
6. Install the precleaner (if equipped) into the air
cleaner cover.
7. Reinstall the air cleaner cover and secure with the
cover knob.
NOTE: Damaged, worn, or loose air cleaner
ȱȱȱęȱȱȱ
the engine causing premature wear and
failure. Tighten or replace all loose or
damaged components.
Air Intake/Cooling System
Clean Air Intake/Cooling Areas
To ensure proper cooling, make sure the grass screen,
ȱęǰȱȱǰȱȱȱ¡ȱ
surfaces of the engine are kept clean at all times.
Under extremely dusty or dirty conditions, pay extra
Ĵȱȱȱǯ
NOTE: Operating the engine with a blocked grass
ǰȱ¢ȱȱȱȱęǰȱȦȱ
cooling shrouds removed, will cause engine
damage due to overheating.