Kohler KG180 - Page 58

58 TP-6694 2/25
Menu Summary List Continued (Legend: ● First level submenu, ○ second level submenu)
Voltage Regulator Menu
(DEC3000 before
Version 3.0.25)
Digital Inputs Menu
Analog Inputs Menu
Event Log Menu
• Enter Voltage Regulator?
(Yes or No) *
o Voltage Regulator
Adjust
o Exit Voltage Regulator
• DIn A1
• DIn A2 (Reserved for wait to
start software on select diesel
generators)
• DIn A3 (Reserved for
Enclosure Temperature: High
Shutdown on select Telecom
units only)
• AIn A1 (factory
reserved and not user
programmable)
• AIn A2
• AIn B1 (with I/O
Board)
• AIn B2 (with I/O
Board)
• See the section titled:
Controller Fault
Diagnostics for a list of
items that can appear in
Event Log
Volt Select Menu (DEC3000
Version 2.8.22 or higher, and
APM402)
Voltage Regulator Menu
(DEC3000 Version 3.0.25
or higher, and APM402)
• DIn B1 (with I/O Board)
• DIn B2 (with I/O Board)
• Volt Select: *
o 120/240 V 1 Ph
o 120/208 V 3 Ph
o 139/240 V 3 Ph
o 277/480 V 3 Ph
o 120/240 V 3 Ph
• Voltage Regulator Voltage
Adjust *
• Reset Voltage Regulator
Settings *
o Reset Voltage
Regulator?
Digital Outputs Menu
• DOut A1
• DOut B1 (with I/O Board)
• DOut B2 (with I/O Board)
• DOut B3 (with I/O Board)
• DOut B4 (with I/O Board)
• DOut B5 (with I/O Board)
Battery Charger 1 Menu
• Output Volts
• Output Amps
• Charger State
• Software Version
• Reduced Out
• Temperature
Compensation
Battery Charger 2 Menu
• Output Volts
• Output Amps
• Charger State
• Software Version
• Reduced Out
• Temperature
Compensation
* User-Defined (changeable) Menu Displays. Use SiteTech™ software to change other settings including User-Defined Menu Displays.
NOTE:
Some changes require activating the calibration or adjustment mode. Some displays may only appear when in the calibration or adjustment
mode. Refer to the section titled: Reviewing Menu Displays to activate the calibration or adjustment mode.