90
Reassembly
KohlerEngines.com 32 690 03 Rev. N
3. Position covers on cylinder heads. If a pulse style fuel pump is used valve cover with pulse tting hole must be
installed on side 2. Install screws in each cover and nger tighten.
4. Torque valve cover fasteners to 13.6 N·m (120 in. lb.), using sequence shown.
Install Spark Plugs
1. Check gap using wire feeler gauge. Adjust gap to 0.76 mm (0.030 in.).
2. Install plug into cylinder head.
3. Torque plug to 27 N·m (20 ft. lb.).
To Next Page
Loading...
