Need help?Do you have a question about the Kohler OPIAZ and is the answer not in the manual?
General| Brand | Kohler |
|---|---|
| Model | OPIAZ |
| Category | Plumbing Product |
| Language | English |
Disconnect water supply, flush, and remove the old toilet pan and cistern.
Determine and position the connector between the pan outlet and waste pipe.
Use a template to mark the correct positions for floor fixing kit holes.
Install toilet using bracket, anchor, washer, and screw for floor fixing.
Install toilet using screws and anchors directly into pre-drilled holes.
View cistern components for OVE, PANACHE, OPIAZ, PARLIAMENT, PERSUADE, ESCALE models.
Center the cistern gasket on the pan inlet and securely tighten the screw.
Connect the supply shut-off valve to the supply hose and toilet shank.
Disassemble, measure, cut, and reassemble push rods for the flush buttons.
Fit the tank lid and test the flush buttons, adjusting rods as required.
Release and assemble Flush Valve A by turning and pushing components.
Release and assemble Flush Valve B by squeezing tabs and pressing components.
To Next Page
