EasyManua.ls Logo

Kohler SH265 - User Manual

Kohler SH265
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SAVE THIS MANUAL FOR FUTURE REFERENCE
P
art No. 7108467 Rev. 0 JAN 2016
PRESSURE WASHER
INSTRUCTION MANUAL
If your pressure washer is not working properly or if there are parts missing or broken,
please DO NOT RETURN IT TO THE PLACE OF PURCHASE. Contact our Customer
Service Department at 1-877-362-4271.
IMPORTANT: Please make certain that the person who is to use this equipment carefully
reads and understands these instructions before operating.
NOTE: Photographs and line drawings used in this manual are for reference only
and do not represent a specific model.

Table of Contents

Other manuals for Kohler SH265

Preview: Owner's Manual
Owner's Manual24 pages

Questions and Answers

  • J
    Justin BrownAug 1, 2025
    Why won't my Kohler Pressure Washer engine start?
    • J
      Jeremiah GrantAug 1, 2025
      Your Kohler Pressure Washer engine might not start due to several reasons: there may be no fuel, so add fresh fuel; pressure may have built up, so squeeze the gun trigger to relieve pressure; the choke lever may be in the "No Choke" position, so move it to the "Choke" position; the spark plug wire may not be attached, so attach it; the engine switch may be in the OFF position, so place it in the ON position; or the choke lever may be in the "Choke" position on a hot engine, so move it to the "No Choke" position.
  • S
    smartinezAug 8, 2025
    What to do if my Kohler Pressure Washer has no or low pressure on initial use?
    • C
      colton14Aug 8, 2025
      If your Kohler Pressure Washer has no or low pressure upon initial use, it could be due to several factors: the spray wand may not be in high pressure; the water supply may be low, ensure it is at least 5 gpm @ 20 PSI; there might be a leak at the high-pressure hose fitting, so repair the leak and apply sealant tape if necessary; the nozzle could be obstructed; the water filter screen may be clogged, so remove and clean the filter; there might be air in the hose, so turn off the engine and water source, disconnect the water source, remove air from the hose, reconnect, and squeeze the trigger to remove remaining air; the choke may be in the “Choke” position, so move it to the “No Choke” position; or the high-pressure hose may be too long, so use a hose under 100 feet (30 m).
  • S
    Susan SanchezAug 13, 2025
    What to do if my Kohler Pressure Washer won't draw chemicals?
    • A
      Amy PowellAug 13, 2025
      If your Kohler Pressure Washer won't draw chemicals, the spray wand may not be in low pressure; the chemical filter may be clogged, so clean it; the chemical screen may not be in the cleaning solution, so make sure the end of the detergent siphon hose is fully submerged; the chemical may be too thick, so dilute it to the same consistency as water; or the pressure hose may be too long, so lengthen the water supply hose instead.
  • J
    Joseph SnowAug 19, 2025
    How to fix water leaking at the gun/spray wand connection on my Kohler Pressure Washer?
    • M
      Matthew CrossAug 19, 2025
      If water is leaking at the gun/spray wand connection of your Kohler Pressure Washer, check and replace any worn or torn o-rings, and tighten any loose hose connections.
  • D
    Daniel MccartyAug 26, 2025
    How to fix oil leaking at the pump on my Kohler Pressure Washer?
    • M
      Michael DixonAug 26, 2025
      If there's oil leaking at the pump of your Kohler Pressure Washer, tighten any loose drain plugs; check and replace worn drain plug o-rings and fill plug o-rings; check for the correct oil amount; drain and fill with the correct type of oil if incorrect oil was used; clean a clogged vent plug or replace it if the problem persists; and clean or replace the air filter if it's filled with oil.

Summary

IMPORTANT SAFETY INSTRUCTIONS

Carbon Monoxide Safety

Warns about CO poisoning from engine exhaust and provides usage guidelines.

Injection and Injury Risks

Highlights risks of injection injuries and the need for trained operators.

Chemical Exposure Warnings

Alerts to chemicals known to cause cancer and birth defects in California.

RISK OF EXPLOSION OR FIRE

Fuel Handling and Flammability

Details risks of gasoline, vapors, storage, and handling.

Ventilation and Placement Hazards

Advises on proper placement to avoid overheating and fire hazards.

Chemical and Solvent Hazards

Warns against using corrosive chemicals or flammable solvents.

RISK TO BREATHING (ASPHYXIATION)

Engine Exhaust Gas Dangers

Details risks of carbon monoxide and toxic gases from engine exhaust.

RISK OF FLUID INJECTION AND LACERATION

High-Pressure Fluid Injection Dangers

Explains dangers of high-pressure spray penetrating flesh.

Hose and Fitting Integrity

Stresses checking hoses and fittings for leaks and damage.

Maintenance Pressure Relief

Advises relieving system pressure before maintenance.

Safe Spraying Practices

Provides guidance on nozzle handling and spray direction.

RISK OF INJURY FROM SPRAY

Projectile Hazards from High-Speed Spray

Warns about high-velocity spray causing objects to break.

Protective Gear and Trigger Lock

RISK OF UNSAFE OPERATION

General Operational Safety Rules

Safe Starting Procedure

Gun and Wand Handling

RISK OF INJURY OR PROPERTY DAMAGE WHEN TRANSPORTING OR STORING

Fuel and Oil Leak Prevention

Upright Storage and Transport

RISK OF ELECTRICAL SHOCK

Electrical Safety Precautions

Warns about spraying electrical outlets and switches.

RISK OF CHEMICAL BURN

Chemical Compatibility and Protection

Advises on using recommended cleaners and wearing protective clothing.

RISK OF BURSTING

Tire Inflation Safety

RISK OF HOT SURFACES

Contact with Hot Components

ASSEMBLY INSTRUCTIONS

Unpacking and Handle Assembly

Wand, Gun, and Nozzle Connection

Pre-Start Oil Checks

STARTING THE PRESSURE WASHER

Pre-Start Safety Warnings

Lists critical safety warnings and checks before starting the engine.

Fueling and Hot Surface Precautions

Details safe fueling practices and avoiding hot surfaces.

PRIOR TO STARTING

Fuel, Oil, and Water Supply Checks

Air Purging and Nozzle Selection

STARTING AND OPERATING THE ENGINE

Engine Start Procedure and Safety

Details engine starting, kickback prevention, and safe operation.

Trigger Lock Usage and Operation

SHUTTING DOWN THE UNIT

Post-Use Chemical Rinse and Shutdown

TROUBLE SHOOTING GUIDE

Engine Start Issues

No or Low Pressure Troubleshooting

TROUBLE SHOOTING GUIDE (continued)

Chemical Draw and Pressure Issues

Oil Leaking at Pump

Leaks and Pump Pulsation

Kohler SH265 Specifications

General IconGeneral
Compression Ratio8.5:1
Fuel SystemCarburetor
Lubrication SystemSplash
Oil Capacity0.6 liters
Ignition SystemElectronic
Dry Weight50 lbs (22.7 kg)

Related product manuals