TP-5353 8/94 Safety Precautions and Instructions V
Hazardous Noise
Hazardous noise.
Can cause loss of hearing.
Never operate generator set without a muffler or
with a faulty exhaust system.
CAUTION
Hazardous Voltage/
Electrical Shock
WARNING
Hazardous voltage.
Moving rotor.
Can cause severe injury or death.
Do not operate generator set without all guards and
electrical enclosures in place.
WARNING
Hazardous voltage.
Backfeed to utility system can cause property
damage, severe injury, or death.
When generator set is used for standby power, use
an automatic transfer switch to prevent inadvertent
interconnection of standby and normal sources of
supply.
Hazardous voltage can cause severe injury or
death. Whenever electricity is present, there is the
hazard of electrocution. Open main circuit breaker on all
power sources before servicing equipment. Electrically
ground the generator set and electrical circuits when in
use. Never come into contact with electrical leads or
appliances when standing in water or on wet ground, as
the chance of electrocution is increased under such
conditions.
Hazardous voltage can cause severe injury or
death. Disconnect generator set from load by opening
line circuit breaker or by disconnecting generator set
output leads from transfer switch and heavily taping
ends of leads. If high voltage is transferred to load
during test, personal injury and equipment damage may
result. Do not use the safeguard circuit breaker in place
of the line circuit breaker.
Hazardous voltage can cause severe injury or
death. Follow instructions of test equipment
manufacturer when performing high-voltage test on
rotor or stator. An improper test procedure can damage
equipment or lead to future generator set failures.
Hazardous voltage can cause severe injury or
death. Do not expose the photo transistor board to any
external light source, as exposure to light causes high
voltage. Keep foreign sources of light away from photo
transistor board during testing. Place black electrical
tape over LED of circuit board (mounted on generator
set end bracket) before starting generator set with end
cover removed.
Hazardous voltage can cause severe injury or
death. Be sure that foil side of photo transistor board,
end of shaft, and threaded holes are clean and free of
metal particles and chips. Metal debris may short-circuit
photo transistor board and cause hazardous voltage in
generator set. AC voltmeter must s how correct output
before generator set may be reconnected to l oad.
To Next Page