VI Safety Precautions and Instructions TP-5353 8/94
Hazardous voltage can cause severe injury or
death. Make sure leads C and E leading to SCR
assembly (one-piece) are connected to the
corresponding terminals. Reverse connection of these
leads or grounding of the C (red) lead will turn the SCR
assembly full-on resulting in hazardous output voltage.
Hazardous voltage can cause severe injury or
death. Electrical shock may occur if battery charger is
not electrically grounded. Connect battery charger
enclosure to ground of a permanent wiring system. As
an alternative, run an equipment grounding conductor
with circuit conductors and connect to equipment
grounding terminal or lead on battery charger. Perform
battery charger installation as prescribed in equipment
manual. Install battery charger in compliance with all
local codes and ordinances.
Hazardous voltage can cause severe injury or
death. Reconnect battery correctly to avoid electrical
shock and damage to battery charger and battery(ies).
Have a qualified electrician perform installation.
Hazardous voltage can cause severe injury or
death. Service day tank Electrical Control Module
(ECM) as prescribed in equipment manual. Disconnect
power to day tank before servicing. The power is
disconnected when the day tank ECM OFF pushbutton
is engaged. However, 120 volts AC is still present within
the ECM when the POWER ON light is on. Be sure that
generator set and day tank are electrically grounded.
Do not operate when standing in water or on wet ground
as the chance of electrocution is increased under such
conditions.
Hazardous voltage can cause severe injury or
death. Short circuits can cause bodily injury and/or
equipment damage. Do not contact electrical
connections with tools or jewelry while adjustments are
made. Remove wristwatch, rings, and jewelry that can
cause short circuits.
Hazardous voltage can cause severe injury or
death. Engine block heater can cause electrical shock.
Remove engine block heater plug from electrical outlet
before working on block heater electrical connections.
Hazardous backfeed voltage can cause severe
injury or death. Install a transfer switch in standby
power installations to prevent connection of standby
and other sources of power. Electrical backfeed into a
utility electrical system can cause serious injury or death
to utility personnel working on transmission lines.
Heavy Equipment
WARNING
Unbalanced weight.
Improper lift can cause severe injury or death
or equipment damage.
Do not use lifting eyes.
Use lifting bars through holes in skid to lift
generator set.
To Next Page