-9 -
Installation procedure:
Remove the sticker from the front panel.
1)
Put the unit into the installation hole.2)
The installation place should be strong
enough to avoid the enlargement of
noise or vibration.
Installation assistance:
Wall
Sunshade
board
Rubber
plate
Support
Horizontal line
●
condensation water can be drain
When installing the unit, it should slant
down to the back to make sure the
away conveniently.(Slant about 3
(Shown at right figure.)
。
ed
。
1 )
+
-
。 。
+
-
3 1
mandatory
fixed
on the building (shown at the right
not, iron support / bracket has to be used
enough to support the air conditioner.if
figure).Using an iron support / bracket is
outdoors then the iron support should be
inlet at the side grille.
sunshade
board,
don’t
let it block the air
The installation hole should be strong
●Use Iron Support
Using a sunshade board is optional though
●
Use Sunshade Board
sponge
or foam.
3)
Fill up the sews in the cabinet with
●
sunshade board. When installing the
should contact the
seller
for
installing the
sunlight. If there is no cover on it,you
be dropped into it and avoid direct
an air conditioner
should
avoid
anything to
To Next Page
Loading...
