-11 -
Notes for installation
Noise
● Don’t pull the power cord forcibly.
● Air switch (thermal-magnetic breaker) should be installed in the circuit.
● If the supply cord is damaged,it must be replaced by the manufacturer or
● done according to the local wiring regulations.
● Install in a location where it is strong enough to avoid
increase of noise and vibration.
● Use correct power outlet for air conditioner. Do not use plug
adaptor because it can overheat and cause fire.
All the electrical work must be
addition, charges to this must be paid.
the direction of an Authorized Kolin Technician. In
contact the seller first. Then it must be done under
Before relocating the air conditioner, you should
Relocate
●
Please use the safety support.
●
Please contact the seller as soon as there is strange noise during operation.
●
Be sure that the hot air or noise will not cause inconvenience to the neighbors.
to avoid increasing of noise.
●
Don’t put anything in front of the outlet of the unit
●
An all-pole disconnection switch having a contact separation of at least 3mm
regulation.
●The air conditioner should be installed in accordance with national wiring
with wiring diagram on the unit.
necting method of each individual element with one another should accord
●
Connecting method between air conditioners and power cord and intercon-
and leakage current should be less than 30mA.
●
Must be connected with ground reliably.
Electric wiring
To Next Page
Loading...
