Kolver EDU 2AE Series - Page 11

Vers. 120723 11
3. Press OK to confirm. If you choose OFF, calibration will be interrupted and no torque value will be
displayed. You choose ON, calibration will continue and the following screen will be displayed:
-
-
-
-
-
-
-
-
S
T
E
P
-
-
1
-
-
-
-
-
E
n
t
e
r
p
e
r
c
e
n
t
a
g
e
M
I
N
4. Set the first torque level at 20% percentage by pressing .
-
-
-
-
-
-
-
-
S
T
E
P
-
-
1
-
-
-
-
-
E
n
t
e
r
p
e
r
c
e
n
t
a
g
e
2
0
%
5. Press OK. You will see:
-
-
-
-
-
-
-
-
S
T
E
P
-
-
1
-
-
-
-
-
S
t
a
r
t
t
e
s
t
O
K
c
o
n
f
i
r
m
E
S
C
q
u
i
t
Complete a screwing cycle on the mini k5 and take note of torque value.
6. Press OK, then the display will show:
-
-
-
-
-
-
-
-
S
T
E
P
-
-
1
-
-
-
-
-
E
n
t
e
r
t
o
r
q
u
e
v
a
l
u
e
:
0
0
.
0
1
N
m
Set the torque value by pressing and press OK again to save. You will see:
-
-
-
-
-
-
-
-
S
T
E
P
-
-
2
-
-
-
-
-
E
n
t
e
r
p
e
r
c
e
n
t
a
g
e
:
2
2
%
7. Set the percentage of the second torque to 30% by pressing and press OK.
8. Repeat the procedures described on points 4 and 5.
9. When calibration ends, “Setting end” will be displayed. You will hear two beep sounds, too.
Now you are ready to work and see the correct torque on the display.