Manual EDU 2AE/TOP and EDU 2AE/TOP/TA Rev. 3 Page 10
3) Ext box: It allows to enable or disable the external switch box. ON = switch box enabled; OFF = switch
box disabled.
4) Barc. mode: – Barcode mode: It allows to choose the barcode mode.
OFF: barcode disabled.
ON prog: you can select the program to be executed by scanning the bar code of the product. The
unit compares the scanned code to the one previously entered in each program (see point 27: Barc.
Set.). If the two codes match, the program is loaded; otherwise it will display Error Barcode. The
scanned product code is also printed on the serial port of the control unit (see paragraph “serial
print”).
ON S.N.: the product code is required before running a program or a sequence. The product code is
printed on the serial port of the control unit.
ON Seq.: you can set the Sequence by scanning its barcode. The code scanned is compared with
the sequence entered in the menu (see point 5: Ins. Barcode Seq on Menu Sequence). If the
two codes match, the sequence set is loaded, otherwise display “Repeat scan”. The read
code is also printed on the serial port of the control unit (see section Serial Print).
5) Ins. Barcode Seq: When ON on “Barc. Mode → ON Seq.”, you have to scan the barcode to enable the
Sequence.
6) Reset seq.: When ON, you can reset the Sequence (pushing the Reset button).
7) Aut. res seq- Automatic Reset Sequence: When ON, the control unit automatically resets after the
end of the sequence. When OFF it is necessary to press OK at the end of each sequence.
OPTION MENU:
1) Language: This option allows to choose among 6 languages: English, German, French, Italian,
Portuguese and Spanish.
2) Change password: You can change password (see point 3).