10. HANDLING RADIO CONTROL OPERATION
3-20
WARNING
If the following procedures are not followed, the machine may suddenly start on slopes.
NOTICE
In cold weather, preheating must be carried out before the engine is started. This operation cannot be car-
ried out by radio control, so carry out the preheating manually.
1. Set the radio control/on-board selector switch to the
RADIO CONTROL position.
Radio control operation: Operate switch to inside of
machine
On-board operation: Operate switch to outside of machine
2. Set the fuel control dial to the MIN position.
Set the travel lever to the N position.
3. Turn the starting switch to the ON position.
If any error is displayed, check the cause.
To Next Page
