OPERATION 10. HANDLING RADIO CONTROL
3-21
4. Set the parking lever to the FREE position (raised).
NOTICE
When the above procedure is followed, electricity is sup-
plied to the radio controller, and when the radio control is
operated, the parking brake is applied.
5. Checks before starting for transmitter, receiver unit, and controller
When operating the radio control, even if radio control operation is a started with all the switches ON, the
receiver may take this as a reception error and it may not be possible to operate the radio control. For this
reason, check that the condition is as follows before starting operations.
● Install a charged battery to the transmitter.
● Neutral check for transmitter
6. Turn the transmitter key switch to position 1.
This turns the power on.
All the machine lights and rotating lamps light up for
approx. 2 seconds, then go out.
Engine speed control switch` LOW position
Control levers Neutral (levers at central position)
Emergency stop switch Not pressed
Push button switch on control lever Not pressed
Set transmitter horizontal Transmitter must not be tilted
START
To Next Page
