RECOMMENDED APPLICATIONS
In addition to the following, it is possible to further increase the range of applications by using various attach-
ments.
DOZING WORK
Cut soil and sand and move them forward. When cutting a
slope surface, it is more efficient to always cut from top toward
bottom.
When dozing toward one side only, operate with angled blade.
(Angle dozer, Power angle power tilt dozer)
LEVELING WORK
NOTICE
Avoid leveling work on rocky or stony ground. It can damage the blade.
To finish the ground to a flat surface after digging or piling soil,
put a full load of soil on the front face of the blade and operate
the blade up and down in small movements while traveling for-
ward.
Finally, float the blade travel at low speed in reverse while pull-
ing the blade over the ground surface.
At this time, hold the lever by hand in FLOAT position for at
least 1 second to make sure that it stays in position.
Avoid running over stones or rocks to protect the blade.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-222
To Next Page
Loading...
