.
MAINTENANCE
MAINTENANCE PROCEDURE
MAINTENANCE
MAINTENANCE PROCEDURE
13. Drain the coolant from sub-tank (4), clean the inside of the
sub-tank, then add coolant until the coolant level is between
the FULL and LOW marks.
If the sub-tank is extremely dirty and it is difficult to clean,
replace it with a new part.
14.
Stop the engine, wait for approximately 3 minutes, add coolant
up to the mouth of the filler port, and tighten the radiator cap (2).
15. Close engine hood (1).
4 - 30
To Next Page
Loading...
