23
After removing the foreign object from the touch
pad, reboot the device by unplugging it from the
power outlet and plugging it in again.
· Temporary non-reaction and
malfunction of the touch sensor in a
dry environment
In this case, professional repair of the machine
is required.
Remove foreign objects from suction hoses.
After checking the filter, clean or replace if
necessary
· Defective flow sensor.
· Blocked suction hose
· Filter is clogged
Inspect the suction hose and replace if
necessary.
Remove foreign objects from suction hoses.
Check the filter and replace if necessary.
Increases the suction level.
· If the suction hose is damaged
· Blocked suction hose
· Filter is clogged
· Suction level is too low
Check and replace breakers in the building.
Check the total power consumption of the dust
collector.
Since the thermostat inside the motor may be
due to overheating, check whether the device
is restarted after about 30 minutes or more.
Replace the motor-side fuse on the PCB.
Check and replace filter.
· Defective breaker in building
· In case the motor does not work
due to overload (temperature,
electricity) operating the thermostat
inside the motor
· When the fuse on the motor side of
the main PCB is disconnected due to
an overload of the power supply
· The dust collector continued to
be used despite the "change filter"
indication
Check the fuse on the power side of the PCB
and replace it when the fuse disconnected.
Since the temperature of the power line is
overheated, press the circuit breaker switch
after cooling the device sufficiently. If you press
this switch when the device is not cool enough,
the switch will not be pressed.
· If the power fuse of the main PCB is
disconnected
· When the contact is shorted due
to the external circuit breaker
operation
If the button on
the touch pad
malfunctions
The filter
replacement
notification lighted
up shortly after the
filter was replaced
When the suction
power is very weak
When the vacuum
suction unit
suddenly stops
If the power does
not come on
Corrective Action
CausesErrors
Error list
1
13 Error list
To Next Page
Loading...