5
Never extract flammable or explosive gases, vapors, dusts.
Never operate the unit without the suction hose or 3 Joint arm.
Never operate the unit without the complete filtration system (Medium filter, ULPA filter, Cleaning filter).
Always unplug the unit from the wall outlet before beginning any work on the unit’s electrical
components.
Units exhibiting damaged connecting lines, hoses, or other defects must be taken out of service
immediately.
Regularly inspect connecting lines and hoses (e.g., the power cord) for damage (e.g., kinks, cracks,
porosity) or signs of aging.
It is necessary to wear suitable, personal protective equipment when emptying the dust bag or
cleaning, depending on the type of extracted material.
Always wear protective gear when extracting hazardous materials.
When extracting hazardous materials, always refer to the relevant safety data sheets.
Read the operating instructions of the other device and comply with the safety instructions
contained in the document.
The mains socket on the unit is only designed for the purposes specified in the operating
instructions. Connecting other devices may cause material damage.
Before connecting another device, turn off both the dust extractor and the other device.
The unit may only be operated if the information on the nameplate conforms with the specifications
of your local mains power supply.
The Silence Extraction System is an electric device and, a such, carries with it a certain inherent
potential hazard. The unit may not be taken into service until any enquired alterations to comply
with regionally specific power plug configurations have been made.
Such alterations may only be performed by a qualified electrician.
Only intended for indoor use. The unit is only designed for dry applications and may not be operated
or stored outdoors or under wet conditions.
Hazard and Warning InformationB
03 Information for Operators
To Next Page
Loading...