V3F25/18 drive
Installation Instruction
© 2004 KONE Corporation AM-11.65.020
All rights reserved. 20 (42) (E) 2004-01-08
4.4.2 Checking the resolver angle and recording the value
Step Action Note
1 Read the value of Resolver angle
(6_61)
parameter.
If the value is 0, restart the adjustment.
It is recommended to
repeat the
adjustment to get a more accurate
angle value.
If no other possibility, resolver angle can also be found manually by entering the
value of
Resolver angle (6_61) parameter in the range of 1 - 360 degrees.
Change the value by increments of 20 degrees. Attempt to run the car after each
increment. Resolver angle is satisfactory when the car runs. Fine tuning will be
required before final commissioning.
2 Select
Save (6_99) parameter. 0 is blinking in the display.
Turn 0 to 1 and press ACCEPT. 0 turns steady.
3 Check that correct value is recorded.
To Next Page
Loading...
