Kone V3F25 - Appendix B. Buzzer warnings

V3F25/18 drive
Installation Instruction
© 2004 KONE Corporation AM-11.65.020
All rights reserved. 35 (42) (E) 2004-01-08
APPENDIX B. Buzzer warnings
• [ * ]: a short beep
• [ __ ]: a long beep
• [ q ]: 15 sec. delay
• [ m ]: 1 min. delay
• [ ]: approx. 1 sec. delay
• [ _______ ]: continuous beep
Warning Buzzer code
1 Module too hot or cold. [ __ * __ * m ]
2 Motor hot. [ __ * m ]
3 Resolver angle is not adjusted, angle value is zero. [ * * * * q]
4
Resolver Autodetect (6_70) function is activated
- driving to heavy direction (up).
[ * * * * ]
5
Resolver Autodetect (6_70) function: driving to light
direction (down).
[ * * ]
6
Resolver Autodetect (6_70) function: There is a fault in
adjustment procedure.
[ __ * * ]
7
Resolver Autodetect (6_70) function: Angle value could not
be found.
Refer to Initial setting of the resolver angle.
[ __ * * * ]
8 Setup is not done. [ * __ * m ]
9 Setup command is active. [ __ ]
10 Setup: Fault in the elevator shaft devices during the setup. [ __ * * * * q ]
11 NTS error: V
3
F has started NTS deceleration in
normal mode.
[ * * * q ]
12 Parameter value is changed. [ * q ]
13 Position fault in V
3
F. [ * __ ]
14 Buffer and traction tests. [ _______ ]