Konica Minolta bizhub 3300P User Manual

User's Guide
- 193 -
Job prints from the wrong tray or on the wrong paper
Actions
Yes
No
Step 1
1. Check if you are printing on paper that is supported by the tray.
2. Resend the print job.
Does the job print from the correct tray or on the correct paper?
The problem
is solved.
Go to step 2.
Step 2
1. From the Paper menu, set the paper size and type to match the paper
loaded in the tray. To access the Paper menu, do either of the following:
- If the printer is on a network, then open a Web browser and type the
printer IP address in the address field. Then navigate to Settings
>Paper Menu.
Note: If you do not know the IP address of the printer, then print a
network setup page and locate the IP address in the TCP/IP section.
- If the printer is connected to a computer by a USB cable, then open the
Local Printer Settings Utility for Windows or Printer Settings for
Macintosh.
2. Resend the print job.
Does the job print from the correct tray or on the correct paper?
The problem
is solved.
Go to step 3.
Step 3
1. Depending on your operating system, open Printing Preferences or the Print
dialog, and then specify the paper type.
2. Resend the print job.
Does the job print from the correct tray or on the correct paper?
The problem
is solved.
Contact
technical
support.

Konica Minolta bizhub 3300P Specifications

General

Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	50, 000 pages
Memory	256 MB
Warm-up Time	Less than 30 seconds
Type	Monochrome Laser Printer
Supported Operating Systems	Windows, Mac OS, Linux
Print Speed	33 ppm (A4)
Connectivity	USB 2.0, Ethernet
Paper Capacity	250 sheets
First Page Out Time	6.5 seconds or less