Konica Minolta bizhub 3300P User Manual

User's Guide
- 81 -
Standard Parallel [x] menu
Note: This menu appears only when an optional parallel card is installed.
Use
To
PCL SmartSwitch
On
Off
Set the printer to automatically switch to PCL emulation when a print job
received through a serial port requires it, regardless of the default printer
language.
Notes:
• On is the factory default setting.
• When set to Off, the printer does not examine incoming data. The printer
uses PostScript emulation if PS SmartSwitch is set to On. It uses the
default printer language specified in the Setup menu if PS SmartSwitch is
set to Off.
PS SmartSwitch
On
Off
Set the printer to automatically switch to PS emulation when a print job received
through a serial port requires it, regardless of the default printer language.
Notes:
• On is the factory default setting.
• When set to Off, the printer does not examine incoming data. The printer
uses PCL emulation if PCL SmartSwitch is set to On. It uses the default
printer language specified in the Setup menu if PCL SmartSwitch is set to
Off.
NPA Mode
On
Off
Auto
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
• Auto is the factory default setting.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.

Konica Minolta bizhub 3300P Specifications

General

Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	50, 000 pages
Memory	256 MB
Warm-up Time	Less than 30 seconds
Type	Monochrome Laser Printer
Supported Operating Systems	Windows, Mac OS, Linux
Print Speed	33 ppm (A4)
Connectivity	USB 2.0, Ethernet
Paper Capacity	250 sheets
First Page Out Time	6.5 seconds or less