Security Function Ver. 1.01 Feb. 2017 6. Accessing the Service Mode
10
• If a wrong CE password has been entered, no further entry can be made for 5 sec.
Wait, therefore, for at least 5 sec. before attempting to enter the correct CE pass-
word.
• Each time a wrong CE password is entered, the CE password illegal access count
is incremented by one.
When the access to the Service Mode has been successful with the correct CE
password entered, the CE password illegal access count is cleared and reset to 0.
• When “ON” is set for Enhanced Security Mode, access to the Service Mode
through the CE password is restricted by the number of times (1 to 3) set for Pro-
hibited Functions When Authentication Error.
If the CE password illegal access count exceeds the set number of times, the
machine is then set into an access lock state. Then, access to the Service Mode
cannot be made until the access lock state is released.
For the procedure to release the access lock state, see P.11.
• To go from the CE password screen to another, enter the CE password and call the
Service Mode menu to the screen. Then, quit the Service Mode. You can also exit
from the CE password screen by turning OFF and ON the power key; however, be
careful that any jobs entered will be cleared at this time.
6. The Service Mode screen will appear.
NOTE
• If you leave the site with the Service Mode setting screen being displayed, unau-
thorized changes could occur for any set values. When you finish the setting of
Service Mode, or if you have to leave the site by necessity when the Service Mode
has been set, be sure to touch [Exit] to the basic screen.
To Next Page
Loading...
Need help?
General
