Why is the received fax from Konica Minolta Fax Machine blank?
A blank fax received on your Konica Minolta Fax Machine can occur if there's an issue with the telephone connection or the caller's fax machine, or if the caller loaded the pages backward. First, check that your machine can make clean copies. If it can, ask the caller to send the fax again. Also, contact the caller to ensure they loaded the pages correctly.
Why is my Konica Minolta bizhub C25 misfeeding media?
If your Konica Minolta All in One Printer displays a 'Media is misfeeding' message, there are several potential causes. First, ensure the media is correctly positioned in the tray. If the tray is overfilled, remove the excess media to match the allowed amount. Check if the media guides are properly adjusted to the media size. Avoid using warped or wrinkled media; smooth it out or replace it. Also, ensure you're using the correct tray for the media type. Envelopes should only be loaded in Tray 1, and special media like labels or postcards should be in Tray 1 or 2. If you're using custom-sized media, load it into Tray 1 or 2.
What to do if the media misfeed message stays on for Konica Minolta bizhub C25?
If the 'Media misfeed' message persists on your Konica Minolta All in One Printer, it could be due to two reasons. First, try opening and closing the front cover again to reset the machine. Second, ensure that all misfed media has been removed from the media path.
Why is my Konica Minolta bizhub C25 having duplex misfeeds?
If your Konica Minolta All in One Printer is misfeeding during duplex printing, it might be due to unsupported media. Ensure you are using KONICA MINOLTA-approved media. Also, double-check the media path inside the duplex unit to ensure all misfed media has been removed.
What to do if media is misfed in the ADF of my Konica Minolta bizhub C25?
If the ADF on your Konica Minolta All in One Printer is misfeeding media, it could be due to several reasons. Ensure the loaded document meets the required specifications. Also, make sure the loaded document does not exceed the maximum capacity. Finally, verify that the document guides are properly adjusted against the edges of the document.
Why is the fax received from Konica Minolta Fax Machine blurry?
There are several reasons why the fax you received might be blurry. It could be due to incorrect document positioning, a dirty original glass, faint text in the original document, problems with the telephone connection, or issues with the recipient's fax machine. To troubleshoot, ensure the document is positioned correctly, clean the original glass, adjust the resolution for faint text, check the telephone line, and confirm that your machine is operating correctly by making a copy. If the copy is clear, advise the recipient to check their fax machine.
What to do if my Konica Minolta bizhub C25 All in One Printer displays 'OUTPUT JAM OPEN RIGHT DOOR'?
If your Konica Minolta All in One Printer displays 'JAM DISPLAY - OUTPUT JAM OPEN RIGHT DOOR', open the right door, clear the sheet of paper misfed, and then close the door. If the issue continues, turn the power off and then on.
What to do if my Konica Minolta All in One Printer displays 'ORIGINAL DOC. JAM OPEN DOC. FEED COVER'?
If your Konica Minolta All in One Printer displays 'JAM DISPLAY - ORIGINAL DOC. JAM OPEN DOC. FEED COVER (PRESS START KEY)', open the document feed cover, remove any misfed paper, and close the cover. If the issue persists, turn the power off and then on again.
What to do if my Konica Minolta bizhub C25 displays a 'FUSER JAM OPEN RIGHT DOOR' error?
If the Konica Minolta All in One Printer displays 'JAM DISPLAY - FUSER JAM OPEN RIGHT DOOR', open the right door and carefully remove any paper causing the jam. After clearing the paper, close the door properly. If the error persists, turn the printer off, wait a few seconds, and then turn it back on.
What to do if my Konica Minolta All in One Printer says 'PAPER MISFEED OPEN RIGHT DOOR'?
If your Konica Minolta All in One Printer displays 'JAM DISPLAY - PAPER MISFEED OPEN RIGHT DOOR', open the right door, remove any misfed paper, and then close the door. If the issue persists, turn the power off and then on again.
General| Print Technology | Laser |
|---|---|
| Scan Resolution | 600 x 600 dpi |
| Copy Resolution | 600 x 600 dpi |
| Duplex Printing | Yes |
| Connectivity | USB 2.0, Ethernet |
| Functions | Print, Copy, Scan |
| Maximum Paper Size | A4 |
| Print Speed | 25 ppm |
| Copy Speed | Up to 25 ppm (color/black) |
| Paper Size | A6, A5, A4, B5 |
| Interface | USB 2.0 |
| Operating System Compatibility | Windows, Mac |
To Next Page