Basic copy operations
3
C300 3-53
Basic copy operations Chapter 3
– If the binding position for the copy is set to “Auto”, the binding po-
sition is automatically determined according to the orientation of
the loaded original. If the original length is 11-3/4 inch or less, a
binding position along the long side of the paper is selected. If the
original length is more than 11-3/4 inch, a binding position along
the short side of the paper is selected.
– If the binding position for the copy is set to “Auto”, the binding po-
sition is set at the top or at the left.
3 Touch [Binding Direction].
– For a single-sided original, select the binding position for the copy,
and then touch [OK].
– For a double-sided original, select the binding positions for the
original and the copy, and then touch [OK].
4 Touch [Original Direction], select the orientation of the loaded original,
and then touch [OK].
– For details on specifying the original orientation, refer to “Selecting
the original orientation (Original Direction settings)” on page 3-22.
5 Touch [OK].
The Basic screen appears again.
To Next Page
Loading...
Need help?
General
