44
Selecting the Flash/Macro Mode
-You can set the flash mode and macro that best suits the subject.
- Once a mode is set, you can shoot continuously. It is recommended that
the mode should be returned t o AUTO mode (no display) after shooting.
- Also, when you turn the camera OFF, the macro-mode you set is canceled
and the camera automatically returns to AUTO-mode shooting operation
(no display). But the flash-mode setting remains in effect even if you switch
the power OFF and back ON.
1. Turn the power on so that the
LCD monitor is lit.
2. By pressing 왗 or 왘, bring up
the desired mode icon on the
LCD monitor.
Pressing 왘 enables the selection of the following modes.
1) AUTO (Automatic Flash) (p.45)
2) Fill-In (p.45)
3) Off (Flash Override) (p.46)
•Every time 왘 is pressed, the mode symbol will be displayed one by one, through
the list.
Pressing 왗 enables the selection of the following modes.
1) AUTO mode (no display) (p.45)
2) Macro-photo mode (p.46)
•Every time 왗 is pressed, the mode symbol will be displayed one by one, through
the list.
To Next Page
Loading...
