The example uses auto recording. Except for movie recording, the
operation for other exposure modes is the same. Automatic Digital
Subject Program Selection is only available in the auto recording mode.
Place the subject anywhere within the focus frame. Make sure
the subject is within the focus range of the lens (p. 24). For
very close subjects, use the macro function (p. 35).
BASIC RECORDING OPERATION
Press the shutter-release button partway down to lock the
focus and exposure. An AF sensor (a) is displayed to
indicate the subject. Automatic Digital Subject Selection will
choose the appropriate exposure mode, see the facing
page.
The focus signal (b) on the monitor will confirm focus lock. If
the focus signal is red, the camera was unable to locate the
subject. Repeat the previous steps until the signal is white.
The shutter speed (c) and aperture (d) appears and turns
black to indicate the exposure is locked.
a b
c
d
The recorded image can be previewed by continuing to hold
down the shutter-release button after the image is captured.
The instant-playback function can also be used (p.
86).
Camera notes
The access lamp lights indicating image data is
being written to the memory card. Never
remove a memory card while data is being
transferred.
To Next Page
Loading...
Need help?
General
