What to do if media misfeed message stays on Konica Minolta Printer?
If the media misfeed message persists on your Konica Minolta printer, open and close the right side cover again to reset the printer. Also, recheck the media path and remove any misfed media.
Why is my Konica Minolta Printer misfeeding media?
If your Konica Minolta printer is misfeeding media, several factors could be the cause. Ensure the media is correctly positioned in the tray. If there are too many sheets, remove the excess. Adjust the media guides to match the media size. Avoid using warped or wrinkled media. Replace moist media with dry media. Special media should only be loaded in Tray 1. Ensure transparencies or labels are loaded according to the manufacturer's instructions, and envelopes are loaded with flaps facing up.
Why is my Konica Minolta Printer printing blank pages?
If blank pages are printing from your Konica Minolta printer, it could be due to defective or empty toner cartridges; check the toner cartridges, replacing any that are empty. Also, verify that the media type set in the driver matches the media loaded in the printer.
Why does my Konica Minolta magicolor 7450 pull multiple sheets at once?
If several sheets are going through your Konica Minolta printer together, the front edges of the media might not be even; remove the media, even the edges, and reload. The media could also be moist; replace it with dry media. If using transparencies, avoid fanning them due to static electricity.
Why is the media wrinkled when printing with my Konica Minolta magicolor 7450?
Wrinkled media from Konica Minolta printer may be caused by moist media; replace it with dry media. It may be caused by unsupported media; use KONICA MINOLTA-approved media.
Why does the duplex option misfeed on my Konica Minolta magicolor 7450?
If the duplex option is misfeeding on your Konica Minolta printer, ensure you are using KONICA MINOLTA-approved media. Also, recheck the media path inside the duplex option and remove any misfed media.
Why does Konica Minolta magicolor 7450 show a media type error in OS X 10.2?
If a media type, such as “Transparency,” is specified for Tray 3, Tray 4 or Tray 5, a media type error appears and the printer stops. Make sure to specify a media type supported by Tray 3, Tray 4 and Tray 5.
What to do if printing from Acrobat Reader, the pages are not correctly collated or the print job is cancelled on Konica Minolta Printer?
If a printing error occurs with Acrobat Reader, print using the Preview application provided by the operating system.
Why can't I use this name for a custom paper size on my Konica Minolta Printer?
Due to the limitations of Mac OS X, the following names cannot be used as custom paper size names: “Custom” and general paper size names specified in the PPD files, such as “A4” and “B4”. Specify a different name.
What to do if my Konica Minolta Printer power is not on?
General| Type | Color Laser Printer |
|---|---|
| Print Technology | Laser |
| Max Resolution (BW) | 1200 x 1200 dpi |
| Max Resolution (Color) | 1200 x 1200 dpi |
| Memory (Standard) | 256 MB |
| Connectivity | Ethernet, USB |
| Operating Systems Supported | Windows, Mac, Linux |
| Media Size | A4, Legal, Letter |
To Next Page