This is the name of the Document
Page 4
Reset Button
The Release button has two functions: unplug the external USB mass storage
1
,
reset the conguration of the Koobrick Boxi to factory default settings
2
.
1
Unplug the external USB mass storage:
When you press and hold Release button for 2 seconds, the Koobrick Boxi will beep for
0.5 second to hint that your command is detected. At this time, you should release the
Release button immediately if you want to unplug the external USB mass storage device
plugged in USB1 port. The Koobrick Boxi will take several seconds to unplug the USB
mass storage. When the LED of the USB1 port goes off, you can safely detach the USB
mass storage device from this Koobrick Boxi.
2
Restore factory default settings
If you want to reset the conguration of
the Koobrick Boxi to factory default settings, you should press and hold BOTH the
Release button and the Copy button at the same time for more than 5 seconds, the
Koobrick Boxi will beep for 2 seconds to hint that your command is accepted. The Power
LED will keep ashing during the restore process. After the restore is complete, the
Koobrick Boxi will restart itself automatically.
USB
The USB2 port allows you to share your les stored in the USB mass storage
device plugged in.
Note: Please plug the external power of your USB mass storage devices before you
connect them to the Koobrick Boxi.
Note: If you have USB mass storage device (like USB external HDD), please plug it to
this Koobrick Boxi’s USB 2 port, and plug the USB ash disk you wish to share to the
USB 1 port.
On/O Button
When the Koobrick Boxi is not working, switch the Power switch to “1” will switch on
the power and make the Koobrick Boxi start. When the Koobrick Boxi has been
shut down, switch the Power switch to “0” will switch off the power.
Boxi User Manual
Version 1.0
To Next Page
Loading...